MN2360A-A,Top sales MN2360A-A,MN2360A-A DATASHEET -ICSTOCK

Note l. Pulse width and repetition rate should be such that the device junction temp. (Ti) does not exceed Tjmax rating
2. IE, VEC, trr, Clrr & die/dt represent characteristics of the anti-parallel, emitter to collector free-wheel diode.
3. Junction temperature (Ti) should not increase beyond 150YC.
4. Pulse width and repetition rate should be such as to cause negligible temperature rise.
MN2360A-A seller

3-state levels are measured 0.5V from steady-state
active level.
Table 2 0003
MN2360A-A datasheet

080
079
078
077
076
075
074
073
072
071
070
069
068
067
066
065
064
063
062
061
060
059
058
057
056
055
054
053
052
051
MN2360A-A price

At a minimum, a double-sided printed-wiring board
(PWB) with a large component-side ground plane
beneath the transceiver must be used. In applications
that include many other high-speed devices, a multi-
layer PWB is highly recommended. This permits the
placement of power and ground on separate layers,
which allows them to be isolated from the signal lines
MN2360A-A pdf

1. Life support devices or systems are devices or systems
which, (a) are intended for surgical implant into the

body, or (b) support or sustain life, and (c) whose failure
to perform when properly used in accordance with
instructions for use provided in the labeling, can be rea-
sonably expected to result in a significant injury to the
use r.